Vzduchové tepelné čerpadlo na prípravu teplej úžitkovej vodyZákladné s nádržou 200 l. s cievkou V4

Air source heat pump for domestic hot waterBasic with a tank 200 l. with a coil V4https://www.onnshop.pl/library/images/16819681_4fbd78762899d0006787b2f14e8cdef2.jpgPompa heat Basic 200 v4 operating in an air-water system is the optimal source of domestic hot water for single-family houses.The tank integrated with the pump, using an aluminum coil wrapped around the bottom of the tank, heats and prepares 200 liters of hot utility water at a temperature of 55°C for 4 of a family (with an additional source up to 65°C).It meets the requirements of the energy efficiency class A++, which translates into an increase in the efficiency of the heat pump by 28% in the preparation of hot water at a temperature of 40°C - compared to the previous generation.The device also allows you to dry and cool small rooms during operation.Pump installation does not require complicated installation work or expensive drilling.The Basic pump is installed inside the building and requires only hydraulic and electrical connections and air ducts.Provides energy savings thanks to low electricity consumption.Convenient and economical use of the Basic 200 pump is ensured by a new controller with a color touch panel.It allows for rapid heating of domestic hot water. - Party function (heating with a heater with a power of 2 kW - included) and takes care of the health of household members thanks to the Anti-Legionella function, as well as the Winter/Summer function.It also allows you to set domestic hot water heating times. and controlling the circulation pump and the pump of an additional source, e.g. a central heating boiler.An additional spiral coil with an area of ​​1 m² placed inside the tank allows for cooperation with a central heating boiler.The heater's insulation is made of hard polyurethane foam, which effectively limits heat loss.Corrosion protection is provided by ceramic enamel applied using the "na mokro" method and two magnesium anodes.The heat pump achieves a COP of 3,6 (A20/W10-55),, making it eligible for subsidy programs.Thanks to cooperation with a photovoltaic installation, it can be powered in 100% by ecological renewable sources.Coil connections, hot and cold water connections - Gw 1", circulation sleeve - Gw 3/4", sensor cover - 3/8", magnesium anode: 33x250 - plug 5/4" (under the front panel) - %p5 /% pcs.Warranty up to 60 months.Dimensions (H x W x D)/ width/main) 1500/670/670 [mm]CNV453