Electricity meter 3 phase DTS 353-C 80A 3F LCD 4,5M billing MID

Secondary 3-phase 1-tariff digital electricity meter for direct billing measurement DTS 353C 80A MID, 4.5 mod.(MID certification) Three-phase electricity meter with LCD display for alternating voltage 3x230 V / 400 V, 50Hz, is used to measure active electrical energy in direct connection to the circuit.It is intended for secondary invoicing measurements of consumption of individual appliances or appliances in groups (MID certification - according to 2014/32 / EU).It is a precise electricity meter that measures from the minimum values of flowing current (0.25 A) up to 80 A, large backlit LCD display shows the values on the dial from 000000.01 to 999999.99 [kWh] without the power supply after for up to 10 years (depending on the environment), the displayed measured values cannot be deleted.The indicator LEDs flash when a specific phase is taken.The meter has a pulse output (800imp. / 1kWh == & gt; 1x flash = 0.00125 kWh) at terminals (20) S0 + and (21) S0-.This allows the connection of an external device that counts the pulses (S0 according to DIN 43864) generated by the electricity meter.The connection of this additional device is not required for the correct function of the electricity meter.It is mounted on a 35 mm support rail (DIN rail), installation width only 76 mm (4.5 mod.)- & gt; saves space in the switchboard.Screw terminals for convenient connection of conductors up to a cross section of 25 mm2, terminals for neutral conductor "N" are interconnected (galvanically) and it is not necessary to divide the "N" conductor.Tightening torque of bolts: terminal No. 1-8 = 2.0 - 3.0 Nm, terminal No. 20-21 = 1.0 - 1.2 Nm.The actual consumption is less than 2 W. --- Information about S0 output --- S0 is an interface defined by DIN 43864 and every meter should be equipped with it.Likewise, the S0 output can be obtained from a gas meter, a water meter, a heat meter and other devices.Need to know the amount of energy a meter has measured?Thanks to the S0 interface, you can easily, accurately and very cheaply obtain information on energy consumption.Voltage ... 12 to 27 V DC Current ... 27 mA Pulse width ... 90 ms Limit values: max. 60 V DC max. 50 mA What is MID certification?Is the meter "calibrated"?Why is a calibration protocol not included?You can find the answer here at this link.