Bostik Wood H100 Project | 14 kg parquet glue
PRODUCT DESCRIPTION
Hybrid, permanently elastic parquet adhesive.Solvent and silicone free.Ready to use.No pre-evaporation time required.
APPLICATION
For bonding mosaic parquet, floors made of both solid boards (up to 100 mm wide) and two and three-layer boards, on absorbent and non-absorbent substrates.
SURFACE TYPES
Mineral substrates, such as cement screed, anhydrite screed.
SURFACE PREPARATION
The substrate must be dry (for cement screeds up to 2%, for anhydrite screeds up to 0,5% humidity for CM method).If the substrate moisture content is higher than the permissible level, use a barrier in the form of HYTEC E336 XTREM.The surfaces must also be clean, degreased, dust-free, strong, load-bearing, stable, without scratches, cracks, sharp edges, and resistant to compression and stretching.Before preparing the base, read the requirements of the parquet manufacturer.The sanded cement or anhydrite screed should be thoroughly cleaned with an industrial vacuum cleaner.Do not prime.Mastic asphalt screed: new - clean the surface thoroughly with an industrial vacuum cleaner.Do not prime.Prime old mastic asphalt screeds with HYTEC E336 XTREM and then sprinkle the uncured primer layer with quartz sand.Check that the flatness of the substrate is within the following limits: 5 mm difference in length 2 m and 1 mm difference in length 20 cm.If necessary, use Bostik self-leveling compound of the appropriate strength class (depending on the traffic intensity in a given room).
HOW TO USE
Along the perimeter of the floor, leave an expansion gap 5-8 mm between the floor and the walls.Joint dimensions: 0,15% of the largest dimension of the surface to be covered with the floor.Apply WOOD H100 PROJECT evenly to the substrate with a notched trowel.Immediately place the parquet element on the adhesive layer and press evenly.Immediately remove any dirt from the adhesive.Recommended notched trowels Mosaic parquet, two-layer parquet 9 mm thick, length 40 cm): trowel B2 Two-layer parquet ready to 100 cm long: trowel B3-B5Dwuwarstwowy finished parquet in the form of planks up to max. Length 225 cm, three-layer parquet in the form of boards up to max. length 225 cm, large-format boards should be weighted at the ends: float B 5-B11 The given serrations are only a possible solution.The final choice should be made with regard to the construction site, and therefore adapted to the nature of the substrate, the length of the boards and the underside of the parquet elements.
TOOLS
Notched trowel
WEAR
0
1 From
2
3 depending on the trowel used.
CLEANING
Remove uncured adhesive immediately after use with MEK or acetone.
SHELF LIFE
18 months from the date of manufacture.Store the original closed packaging at a temperature from +5°C to +25°C.Protect against freezing.
AVAILABLE PACKAGING
box 14kg