BIS- 411-24V bistable relay

BIS-411 24 V is available in the following versions: BIS-411 24 V - basic model with a single relay 16 ABIS-411-LED- 24 V - with a contact adapted to work with receivers with high starting current, such as: LED fluorescent lamps, ESL fluorescent lamps , electronic transformers, discharge lamps, etc. BIS-411M 24 V - with contact position memory.After switching the supply on, the relay status will be restored as it was in the power off device BIS-411M-LED 24 V - with a contact adapted to work with receivers with high starting current and with the memory of the contact position BIS-411 2 NO 24 V - single-channel with two independent 2 x NO working contacts BIS-411 1R1Z 24 V - single-channel with two independent working contacts: 1 x NO and 1 x NC.What is the operating principle of a bistable relay?The receiver is switched on after a current impulse caused by pressing any momentary button (bell) connected to the relay.The receiver will be turned off after the next impulse or after a power failure.ATTENTION!BIS-411 24 V cannot work with illuminated buttons.Power table Approximate values of the permissible load, more Power supply: 9 ÷ 30 V AC / DC Max load: 16 A Mounting: on a 35 mm rail Electronic bistable relay enables switching on lighting or other device from several different points by means of control buttons connected in parallel.Features: Power consumption: 0.7 W Operation delay: 0.1 ÷ 0.2 s Control impulse current: less than 1 mA Tightening torque: 0.4 Nm Cooperation with illuminated buttons: NO Executive element: relay Functionality: on / off ON time function: NO Number of channels: 1 Contact configuration: 1 × NO / NC Contact separation: YES Resistance to surge currents - cooperation with LED: NO Local control: YES Dedicated central control inputs: NO Radio control: NO State memory after loss power supply: NO Maximum AC-1 load current: 16 A