merXu Protected Payments
Zajistěte si platbu až do převzetí zboží.
HYBRID WIND POWER PLANT 2000W
Micro wind power plant.Recommended for stationary solutions, mounted on the roof of buildings or on a mast.
It is a power plant with high efficiency considering its weight and size.
Like any wind turbine, it should be installed as high as possible, away from obstacles.The installation location has a significant impact on the amount of energy produced.We cannot guarantee energy yield.
Without notification and without permission, it may be mounted on an existing building on a mast up to a height of 3 meters above the highest element of the roof.Remember to ground the mast.
Note: the DEYE on-grid/off-grid hybrid inverter from this set has current Polish certificates.It can be used as on-grid and off-grid.
It has 2 MPPT input.Therefore, you can connect PV panels to one input and a wind turbine to the other.To connect a wind turbine, a bridge should be used to rectify the 3 alternating phase current into 1-fazowy direct current.Additionally, the turbine characteristics must be set in the inverter, i.e. the load depending on the supplied voltage.The default characteristic is set to panels and then charging from the turbine basically does not work!
Micro wind power plant.Recommended for stationary solutions, mounted on the roof of buildings or on a mast.
It is a power plant with high efficiency considering its weight and size.
Like any wind turbine, it should be installed as high as possible, away from obstacles.The installation location has a significant impact on the amount of energy produced.We cannot guarantee energy yield.
Without notification and without permission, it may be mounted on an existing building on a mast up to a height of 3 meters above the highest element of the roof.Remember to ground the mast.
Note: the DEYE on-grid/off-grid hybrid inverter from this set has current Polish certificates.It can be used as on-grid and off-grid.
It has 2 MPPT input.Therefore, you can connect PV panels to one input and a wind turbine to the other.To connect a wind turbine, a bridge should be used to rectify the 3 alternating phase current into 1-fazowy direct current.Additionally, the turbine characteristics must be set in the inverter, i.e. the load depending on the supplied voltage.The default characteristic is set to panels and then charging from the turbine basically does not work!